The Stormwater Industry Association of Australia (SIA) formulated a draft Stormwater Quality Improvement Device Evaluation Protocol (SQIDEP) proposed for use in validation of stormwater treatment devices. This was presented to some Victorian water industry and regulatory parties for comment in February 2016. The project’s aim was to provide scientific support for the guidance and/or scientifically supported alternative advice.

The purpose of this review was to investigate scientific literature related to stormwater protocols that can add value to the SQIDEP before its official release in 2018. A number of other international stormwater device evaluation protocols were also investigated. A scientifically defensible protocol would add value to the Australian stormwater industry and allow manufacturers and product end users to have confidence in the process used to assess stormwater treatment devices.

Overall a number of recommendations were proposed to improve the Australian-based protocol. These included: increasing the minimum number of storm events; increasing event coverage; reviewing some of the recommended performance metrics; sampling and analysis for suspended total solids, suspended solids concentration and particle size distribution as well as a range of other pollutants; providing target removal levels for suspended solids based on Australian guidelines; sampling some sequential storm events; and inclusion of operation and maintenance requirements and schedules.

The environmental conditions which cause blue-green algae (cyanobacteria) blooms vary according to location, the climate, and other attributes of aquatic ecosystems. This variety has made it difficult to develop one broadly applicable predictive model for cyanobacterial blooms. Water utilities monitor source waters to implement cyanobacterial risk management programmes but there are no standard protocols while limited information transfer between utilities has prevented the identification of management strategies that do or do not work. This research reviewed literature about early warning systems (Almuhtaram et al., 2021) and source control strategies, conducted a survey of 35 utilities in America and Canada (74%) and Australia (Kibuye et al., 2021) and evaluated selected control strategies. These different types of information were synthesised into decision trees within an overarching guidance document. It was concluded that a 3-tier framework to detect algal blooms which monitored biological activity, then confirmed the identification of cyanobacterial genes and associated metabolites gave sufficient early warning, while multi-barrier control strategies gave field-scale efficacy and enabled timely responses.

Wastewater must be treated to remove four classes of pollutants to levels that regulators consider safe for discharge to the environment: these are nutrients, micropollutants, total suspended solids and pathogens. Utilities are granted licenses to discharge based on the performance of their wastewater treatment plants (WWTPs) and legislation-derived guidelines which consider the social, economic, and environmental impacts of wastewater discharge. The problem is that there are substantial interpretative differences between States and jurisdictions. This research established a standard risk assessment framework that provides a transparent method for assessing the relative benefits of different disposal and treatment options, and which can be applied uniformly across Australia.

European carp have decimated native fish species in the Murray-Darling River. The federally funded National Carp Control Plan proposes using a carp-specific virus to kill the pest-fish, but before doing so are consulting with a broad array of environmental, conservation and other stakeholders, including the water industry. There are concerns that large amounts of dead and decaying carp near water offtakes or storages might overwhelm the capacity of water treatment plants (WTPs) to remove organic matter and taste and odour compounds, and might compromise the production of safe, palatable drinking water. In this research a series of experiments led to the conclusions that medium to high carp densities could be managed by adding a 30 minute procedure to existing WTP methods, and that there would not be an increased risk to public health.

Water treatment plant operators remove cyanobacteria and the toxins they produce from source waters but calculating the amount of treatment needed for effective removal is difficult, particularly in bloom conditions when cyanobacterial cell numbers and toxins change quickly. Current cell counting and toxin measurement can take hours or days to complete, and the results are not available quickly enough to help treatment plant operators respond to changing conditions. There is a need for a real-time method that gives instant results. This research examined the utility of fluorometers; probes that emit light that is ‘reflected’ back at different wavelengths by living cells and other matter in the water and is detected by the fluorometer. It was found that when only one species of cyanobacteria was present, there was a good correlation between the fluorescent signal and cell number, particularly when source waters were clear and not cloudy. Cell numbers did not relate well to levels of toxins or taste and odour compounds. When fluorometers were installed in 13 water treatment plants the correlation between cyanobacteria cell numbers and fluorometer signals was validated, and this led to the conclusion that fluorometers can give early warning of blue-green algae blooms.

The protection of sources of water and catchments is an important method for maintaining water quality; one that can mitigate cost and reliance on downstream water treatment and disinfection. Catchment protection requires risk assessment, but water quality management approaches were not originally developed for natural environments, and ecosystem-based methods (such as the Ecological Risk Assessment methodology), require complex data inputs often unavailable to water utilities.

This paper discusses various water quality risk management techniques and proposes a step-by-step catchment risk assessment methodology that is compatible with the Australian Drinking Water Guidelines.

Cyanobacterial blooms in surface waters are a source of cells, taste and odour compounds, and a range of toxins. This research optimised treatment processes for the removal and control of cyanobacteria and their metabolites from a range of source waters. It was concluded that pre-chlorination is not advisable when cyanobacteria are present, but that in some situation’s potassium permanganate is a viable alternative. Although all three tested coagulants; ferric chloride, aluminium chlorohydrate and aluminium sulphate (alum) removed 90 to 95% of cells, alum at pH 6.3 was the most cost-effective. Maintaining pH > 6 reduced cell lysis and metabolite release. Since cyanobacteria in sludge remained viable for 2-3 weeks it was recommended that sludge detention in the clarifiers should be minimised.

Remote and regional Australian communities commonly produce potable water by removing salt from brackish groundwater. Existing desalination technologies, such as reverse osmosis (RO) have high electrical energy and technical requirements. Groundwaters often contain high levels of silica (quartz) which, together with the salts, form scale which blocks RO membrane and other components which are expensive to replace. This research examined an alternative desalination process: capacitive deionisation. Laboratory-scale experiments found that single-walled carbon nanotubes were the best material to use for electrodes, that membranes placed before the electrodes increased efficiency of salt removal and decreased energy usage, while silica, which lacks a charge that would bind it to either the positive or negative electrode, did not form scale deposits nor interfere with the desalination process. A full-scale version of this unit was tested onsite in the Northern Territory and described in WaterRA Project 1047.

Some remote and regional areas of Australia rely on groundwater. A problem with this is that naturally occurring salts, such as calcium carbonate, make the water ‘hard’ and cause scale deposition on the elements used to heat water. Scale also blocks taps and showerheads. This research examined different methods for predicting the amount of scale that a groundwater might form and also considered the pro’s and con’s of various treatment technologies which prevent scale formation. The consideration of community size and the chemical characteristics of different groundwaters was incorporated into this assessment and recommendation for scale prevention.